Roth Technologies, LLCIndustrial seals for moving wire processes
MWS tooling · in development

Hole-punching tools for MWS seals.

Roth Technologies is developing tooling to help customers prepare the tip opening in MWS seals. The tooling is planned as a product for sale to customers who prepare seals in-house.

Development concept

A guided setup for making the opening.

The current concept combines a hollow punch, alignment guide, bushing, support mandrel and sacrificial anvil insert. The tool is intended to support a repeatable cutting setup while the operator selects an opening suited to the wire and process.

MWS seals are supplied without a tip opening. The opening is created for the intended wire setup.

Development status: This illustration is a concept, not a released tool specification. Tool geometry, supported hole sizes, final relaxed hole size, procedures, and availability are still being developed.
Concept cross-section of a hollow punch and guide tooling aligned over an MWS seal supported on a tapered mandrel and sacrificial insert
Illustrative development concept based on the MWS seal cross-section. Not to scale; dimensions and tooling details are not a released specification. Open full-size concept drawing.
Fit and recovery

Final opening size needs to be verified.

EPDM recovery varies with the material, punch geometry, sharpness, lubrication and support conditions.

No universal recovery allowance is applied.

The website Hole Sizing model estimates target relaxed hole diameters for a selected wire and fit. It does not apply a universal punch-to-hole recovery percentage or prescribe punch outside diameters. The user should verify the finished hole with non-contact measurement and develop a process-specific punching guideline.

Open Hole Sizing

Interested in the tooling? Contact Roth Technologies to discuss the concept or share the hole sizes your setup needs.

Contact us about punch tooling