Roth Technologies · Moving Wire Seals

MWS MeniscusLab

Free-Meniscus PTFE Wire-Coating Simulator

MWS MeniscusLab illustrates how wire speed, PTFE solids content, viscosity, and pass count affect estimated coating build in a continuous wire application. MWS units seal the moving wire at the treatment tube entry and exit. The model and its status indicators are illustrative, not validated production settings; confirm results using the actual dispersion, wire, and measured coating.

Process & Dispersion Inputs

Bare Wire Diameter (D) 0.0300 in (0.762 mm)
Line Speed (U) 8.2 ft/min (0.042 m/s)
Tower Passes (N) 4 passes
PTFE Solids Content (ws) 30 wt% (16.6 vol%)
Dynamic Viscosity (η) 5.0 cP (0.0050 Pa·s)
Surface Tension (γ) 30.0 mN/m (0.030 N/m)
Target Dry Wall Thickness 0.00050 in (12.7 μm)

Simulation Output & Geometry

Total Dry PTFE Wall
--
--
Final Coated OD
--
--
Capillary Number (Ca)
--
--
Max Wet Film / Pass
--
Crack limit: ~15–20 μm dry
Calculating...
Magnified Wire Cross-Section (Exaggerated Coating Scale)
Cumulative Dry Wall Thickness vs. Target
Pass In OD (in) Wet Film (μm) Dry Layer (μm) Cum. Wall (in) Cum. Wall (μm) Out OD (in)

Model: Cylindrical LLD wet pickup hwet = 1.34 · R · Ca2/3 where Ca = ηU/γ, valid for Goucher number Go = R/lc < 1 and Ca ≪ 1. Sintered PTFE density = 2,150 kg/m³; aqueous carrier = 1,000 kg/m³.